How To Assemble Your Ceiling Fan Blades; How To Assemble Your Light Kit - Fanimation XENO FP6729B Series Manual

How to Assemble Your Ceiling Fan Blades

INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Position blades over the threaded posts and secure
with the 3/16˝-24 serrated head screws and flat
washers. (Figure 1)
CAUTION
To Reduce The Risk Of Electric Shock, Disconnect
The Electrical Supply Circuit To The Fan Before
Installing Light Kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the
remaining two screws. (Figure 1)
2. Assemble the light kit to the motor assembly
support bracket using the two key slots in the
light kit. Replace the previously removed screw and
securely tighten all three screws. (Figure 2)
3. Remove one of the three screws in the light kit
and retain the screw for later. Slightly loosen the
remaining two screws. (Figure 3)

How to Assemble Your Light Kit

HARDWARE USED:
3/16 -24
SERRATED HEAD
SCREWS
FLAT WASHER
Motor Assembly
Motor
Assembly
Light Kit
Light Kit
9
3/16˝-24 Serrated Head Screw
with Flat Washer (3 per blade)
Figure 1
x 9
x 9
Figure 1
Figure 2
Figure 3