Step 3 Initializing The Software - Contec COM-2PD-LPE User Manual

Step 3 Initializing the Software

This assigns COM ports to the serial ports on the board. You can also change a previously assigned
COM port number to a different number.
The COM ports are already assigned by the hardware installation step. Run Device Manager as
described below if you wish to view or modify the COM port settings.
Start Device Manager
(1) Select "System" from "Control Panel" and start [Device Manager].
(2) Check that the new COM ports are displayed in the [Ports] folder.
COM-2PD-LPE
* The name of the board
you have just added is
displayed.
- COM-2PD-LPE
2. Setup
21