Table of Contents
Advertisement
Display
Operation
Not Assigned
[Paper Jam 0]
Open/Close Door
[Paper Jam 1]
Open/Close Door
[Paper Jam 2]
Check Inside
[Power Failure]
[Retry Redial?]
[Stop Pressed]
[Toner Empty]
[Toner Low]
8.10
T
ROUBLESHOOTING
Meaning
You are doing in the Add/
Cancel operation, but
there is no jobs waiting.
Paper has jammed in the
feeding area of the paper
tray.
• Paper has jammed in
the paper exit area.
• A paper jam has
occurred in the
manual feeder or the
machine detects non-
feeding from the
manual feeder.
Paper has jammed in the
fuser area.
Power has turned off then
on and the machine's
memory has not been
saved.
The machine is waiting
for a specified time
interval to redial a
previously busy station.
The Clear/Stop button
is pressed during a copy
or fax operation.
The toner cartridge has
run out. The machine
stops printing.
The toner cartridge is
almost empty.
Suggested solutions
Check the display to see if there
is any scheduled job. The display
should indicate them in Standby
mode, for example, Delay Fax.
Clear the jam. See page 8.4.
Clear the jam. See page 8.6.
Clear the jam. See page 8.5.
You need to start again the job
which you were trying to do
before the power failure.
You can press Enter to
immediately redial, or Clear/
Stop to cancel the redial
operation.
Try again.
Replace with a new toner
cartridge. See page 7.9.
Take out the toner cartridge and
gently shake it. By doing this,
you can temporarily reestablish
printing operations.
Advertisement
Table of Contents
