Other Remote Start Features; Low Battery/Low Temp Automatic Starting; Turbo Timer Mode; Pit-Stop Mode - Excalibur RS-275-3DB Operation Manual

Other Remote Start Features

LOW BATTERY/LOW TEMP AUTOMATIC STARTING

This feature will automatically start the engine if the vehicle battery drops below
11 volts or the interior temperature drops to 15 (or 32) degrees fahrenheit� You must
activate these features each time you park your car to use them�
Method 1 - Valet Switch
• Turn the ignition switch "on", then "off" (engine not running), and within 7 seconds
press the valet switch twice� If there is a 2 second delay without additional valet button
presses, the siren will chirp 3 times activating low voltage start mode�
• To activate low temp starting, enter low voltage start mode as described above then,
immediately after the horn honks, press the valet switch 1 time (15 degrees) or 2 times
(32 degrees) within 5 seconds. The siren will chirp to confirm your selection.
Method 2 - With The Controller (Low Volt & Low Temp. @ -15°F Only)
• Within 5 seconds of performing UNLOCK, then LOCK, press the START button� The
siren/horn will chirp to confirm.
NOTE: When low temp start mode is activated, low voltage start is also activated� These
features will operate once every two hours until the ignition key is turned "ON"�

TURBO TIMER MODE

It is typically recommended that vehicles equipped with turbocharged engines allow the
engine to idle after driving to cool the turbocharger� When Installer Programmable Feature
#10 is ON, the system will automatically keep the engine running as follows:
• With the engine running, hold the brake pedal and engage the parking
brake� When the brake pedal is released, the system will keep the engine running for the
programmed time (1, 2, or 3 minutes)�
• Turbo Timer can be bypassed by turning the engine off before engaging the parking
brake� If it's already engaged, step on the brake pedal to turn the engine off�

PIT-STOP MODE

This feature allows you to leave your engine running for making quick errands� To use
this feature, have the engine running normally from the ignition switch and your foot off the
brake pedal. Press the Valet Switch twice; the parking lights will flash and the ignitions will
turn on� Turn the key off and the engine will remain running for the programmed run time�
Run time extender can be used in this mode�

XL PIT-STOP MODE

This feature allows you to leave your engine running for making quick errands� To
use this feature, have the engine running normally from the ignition switch and your foot
off the brake pedal. Press the Valet Switch 6 times; the parking lights will flash and the
ignitions will turn on� Turn the key off and the engine will remain running for 12hrs� Run
time extender can be used in this mode allowing a run time up to 24hrs� This is ideal for
commercial refrigeration trucks, cleaning vans, vehicles w/ PTO, etc�
6