Setting The Daylight Saving Time - TP-Link T2500G-10MPS User Manual

Managing System
Get Time from
NTP Server
Synchronize
with PC's Clock
2) Click Apply.

2.1.4 Setting the Daylight Saving Time

Choose the menu System > System Info > Daylight Saving Time to load the following
page.
Figure 2-6 Setting the Daylight Saving Time
Follow these steps to configure Daylight Saving Time:
1) In the DST Config section, select Enable to enable the Daylight Saving Time function.
2) Choose one method to set the Daylight Saving Time of the switch and specify the
information.
Set the system time by getting time from NTP server.
is accessible on your network. If the NTP server is on the Internet, connect the
switch to the Internet first.
Time Zone: Select your local time zone.
Primary Server: Enter the IP Address of the primary NTP server.
Secondary Server: Enter the IP Address of the secondary NTP server.
Update Rate: Specify the interval the switch fetching time from NTP server, which
ranges from 1 to 24 hours. The default value is 12 hours.
Synchronize the system time of the switch with PC's clock.
System Info Configurations
Make sure the NTP server
Configuration Guide 26