Creating Multicast Vlan And Configuring Basic Settings - TP-Link T2500G-10MPS User Manual

Hide thumbs Also See for T2500G-10MPS:

Table of Contents

Configuring Layer 2 Multicast

Figure 2-4 Multicast VLAN Config

Creating Multicast VLAN and Configuring Basic Settings

In the Multicast VLAN section, follow these steps to enable Multicast VLAN and to finish the

basic settings:

1) Set up the VLAN that the router ports and the member ports are in. For details, please

Configuring 802.1Q

2) Enable Multicast VLAN, configure the specific VLAN to be the multicast VLAN, and

configure the Router Port Time and Member Port Time.

Multicast VLAN

Select Enable to enable multicast VLAN function.

Specify the 802.1Q VLAN to be the multicast VLAN.

Specify the aging time of the router ports in the multicast VLAN. If the router port

does not receive any IGMP general query message within the router port time,

the switch will no longer consider this port as a router port and delete it from the

router port table. The valid values are from 60 to 600 seconds. When the router

port time is 0, the VLAN uses the global time.

IGMP Snooping Configurations

Configuration Guide

Table of Contents