Using The Cli; Example For Port Isolation; Network Requirements - TP-Link T2500G-10MPS User Manual

Managing Physical Interfaces

7.1.4 Using the CLI

Switch#configure
Switch(config)#monitor session 1 destination interface gigabitEthernet 1/0/1
Switch(config)#monitor session 1 source interface gigabitEthernet 1/0/2-5 both
Switch(config)#end
Switch#copy running-config startup-config
Verify the Configuration
Switch#show monitor session 1
Monitor Session:
Destination Port:
Source Ports(Ingress): Gi1/0/2-5
Source Ports(Egress): Gi1/0/2-5
7.2

Example for Port Isolation

7.2.1 Network Requirements

As shown below, three hosts and a server are connected to the switch and all belong to
VLAN 10. With the VLAN configuration unchanged, Host A is not allowed to communicate
with the other hosts except the server, even if the MAC address or IP address of Host A is
changed.
Figure 7-5 Network Topology
1
Gi1/0/1
Gi1/0/1
Gi1/0/2
Host A Host B
Switch
Gi1/0/4
Gi1/0/3
Host C
VLAN 10
Configuration Examples
Server
Configuration Guide 97