Lenovo ThinkSystem SR630 V2 Reference page 39

Complete the following steps until the problem is solved:
1. Use Storcli or LSA to check if there is any warning or critical RAID event.
2. Take proper actions by referring to the MegaRAID user guide.
3. If the problem persists, collect service data log from the XCC WebGUI and contact Lenovo Support.
• FQXSPEA2001I: Sensor [SensorElementName] has deasserted the transition from normal to non-
critical state.
This message is for the use case when an implementation has detected that a Sensor has deasserted a
transition to non-critical from normal.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0521
User Action:
Information only; no action is required.
• FQXSPEA2002I: Sensor [SensorElementName] has transitioned to a less severe state from critical.
This message is for the use case when an implementation has detected a Sensor transition to less severe
from critical.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0523
User Action:
Information only; no action is required.
• FQXSPEM4000I: The [arg1] on system [arg2] cleared by user [arg3].
This message is for the use case where a Management Controller Event Log on a system is cleared by a
user.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0020
User Action:
Information only; no action is required.
• FQXSPEM4001I: The [arg1] on system [arg2] is 75% full.
This message is for the use case where a Management Controller Event Log on a system is 75% full.
Severity: Info
Serviceable: No
Automatically notify Support: No
.
Chapter 2 XClarity Controller events
35