Lenovo ThinkSystem SR630 V2 Reference page 12

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPEM4022I Enclosure/Chassis power supply has problem. Please check the
enclosure/chassis unit power supply for correct operation.([arg1],
[arg2],[arg3],[arg4],[arg5])
FQXSPEM4023I One or more virtual drive are in abnormal status that may cause
unavailable virtual drive. Please check the event logs and if events are
targeted to the same disk then replace the drive. If necessary, contact
technical support for additional assistance.([arg1],[arg2],[arg3],[arg4],
[arg5])
FQXSPEM4024I The RAID controller detected one or more possible configuration
problem within the subsystem. Please check the event logs and if
events are targeted to the same disk then replace the drive. If
necessary, contact technical support for additional assistance.([arg1],
[arg2],[arg3],[arg4],[arg5])
FQXSPEM4025I One or more virtual drive have problem. Please contact technical
support to resolve this issue.([arg1],[arg2],[arg3],[arg4],[arg5])
Drive error was detected by RAID controller. Please contact technical
FQXSPEM4026I
support to resolve this issue.([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4027I Drive error was detected by RAID controller. Please check the event
logs and if events are targeted to the same disk then replace the drive.
If necessary, contact technical support for additional assistance.
([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4028I The port [arg1] of PCIe device [arg2] at [arg3] has link [arg4].
FQXSPEM4029I All PCIe slots on [arg1] may not be functional based upon your current
CPU population.
FQXSPEM4030I A scheduled operation on the RAID controller has encountered an
issue. Refer to RAID Logs under Server Management, Local Storage,
for details.([arg1],[arg2],[arg3],[arg4],[arg5])
FQXSPEM4032I Acoustic Mode [arg1] has been engaged. Fan speed limits are in
place.
FQXSPEM4033I Acoustic Mode [arg1] has been disengaged to allow adequate
cooling.
The bare metal connection process has been started.
FQXSPFC4000I
FQXSPFC4001I The bare metal update application reports a status of [arg1].
FQXSPFC4002I System running in setup.
FQXSPFC4003I UEFI deployment boot mode is enabled for NextBoot.
FQXSPFC4004I UEFI deployment boot mode is enabled for NextAc.
UEFI deployment boot mode has been disabled.
FQXSPFC4005I
FQXSPFW0003I The System [ComputerSystemElementName] encountered firmware
progress.
FQXSPFW2000I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
FQXSPFW2001I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
8
ThinkSystem SR630 V2 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational