Lenovo ThinkSystem SR630 V2 Reference page 128

a. Check if there is a de-asserted event triggered after this event is asserted before entering the OS.
b. If yes, ignore this event because this problem is fixed by recovery algorithm.
c. If no, collect service data log right after this event triggered.
d. Contact Lenovo Support
2. If the sensor is "RAID Vol State":
a. Check whether there is any physical drive removed unexpectedly. Make sure that the drives are
installed correctly in the same sequence as original VD creation.
b. If the problem remains the same after physical check, boot the system in OS (if the original OS is
corrupted, try to use external storage) to collect LXCE log and FFDC log during the failure.
c. Contact Lenovo Support.
• FQXSPUN0019M: Sensor [SensorElementName] has transitioned to critical from a less severe
state.
This message is for the use case when an implementation has detected a Sensor transitioned to critical
from less severe.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0522
User Action:
Complete the following steps until the problem is solved:
1. If the sensor is "PFR PCH":
a. DC cycle the system.
b. If the problem persists, collect service data log right after this event triggered.
c. Contact Lenovo Support
2. If the sensor is "CPU 1 UPILinkErr" or "CPU 2 UPILinkErr":
a. Make sure the heat sink is with sufficient torque on affected CPU location.
b. If the problem persists, collect service data log from the XCC WebGUI and contact Lenovo
Support.
3. If the sensor is "Fan Mismatch":
a. Make sure the type of fans installed meet the thermal requirements of the system configuration.
Refer to the "Thermal rules" or "Technical rules for system fans" in the Maintenance Manual to
select the correct type of system fans.
b. Reboot the XCC for fan detection.
c. If the problem persists, collect service data log from the XCC WebGUI and contact Lenovo
Support.
4. If the sensor is "ME Status":
a. Reboot XCC and see if the problem is still observed.
b. Upgrade or downgrade the UEFI to have ME update and see if the problem disappears.
c. If the problem persists, collect service data log and contact Lenovo Support.
5. If the sensor is "Drive Mismatch":
124
ThinkSystem SR630 V2 Messages and Codes Reference