Lighting - privileg SY-103E9G-P1-C13-L22-600 User Manual

Page GB-20 Care and maintenance
4. Only when replacing:
The two charcoal filters (16) are located
to the right and left of the motor (17).
Loosen the two charcoal filters and re-
move them.
5. Place the new charcoal filters to the right
and left of the motor and tighten them in
an anti-clockwise direction. Allow the lock
to click into place.
6. Place the grease filter (15) with the pins
into the openings.
7. Push the lock (14) to the side; snap the
grease filter (15) shut and release the lock
again.
8. Close the cover (13) again and allow it to
click into place.
The exhaust hood is now mounted to the
wall.
9. Switch the power back on.
10. Dispose of the used charcoal filters with
household waste.

Lighting

WARNING
Risk of injury!
If one of the LEDs ceases to work, it
■
must be changed by an authorised
service technician.
Note for the service technician: This
■
exhaust hood requires LEDs with
the ILCOS D-Code DBS-2/65-H 220-
240 V~, 2 W.
(13)
(14)
(15)