Prerequisites For Installation; Place The Drill Holes - privileg SY-103E9G-P1-C13-L22-600 User Manual

Page GB-12 Materials required for assembly

Prerequisites for installation

You have read chapter „For your safety" on
page GB-4 and understand all the safety no-
tices.

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
hood must be at least 65 cm for gas
stoves.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. Following the diagram shown above,
draw the six drill holes on the wall. Make
sure the distances between the holes are
correct.
3. Drill holes at the marked points, using a di-
ameter that can accommodate the dowels.
4. Place the dowels into the holes.