Inserting/Replacing Activated Charcoal Filters - privileg SY-103E9G-P1-C13-L22-600 User Manual

5. Place the grease filter (15) with the pins
into the openings.
6. Push the lock (14) to the side; snap the
grease filter (15) shut and release the lock
again.
7. Close the cover (13) again and allow it to
click into place.
The exhaust hood is now mounted to the
wall.
8. Switch the power back on.
Care and maintenance
Inserting/replacing activated
charcoal filters
(13)
Activated charcoal filters are required for
circulation air operation. They help combat
odours. They have to be replaced as soon
as the cooking odours can no longer be ade-
quately filtered.
If used frequently, you should change the fil-
ters regularly. Check at least every 6 months
For the source of supply, please see chapter
(14)
„Our Service Centre" on page GB-22.
(15)
1. Unplug the mains plug or switch off the
corresponding circuit.
(15)
2. Flip the cover (13) up.
3. Open the locks (14) on the grease fil-
ter (15) and carefully remove the grease
filter.
Page GB-19
(13)
(14)