Sunricher SR-2803 Manual

RF CCT Controller
Important: Read All Instructions Prior to Installation
Function introduction
On/Off
Control the receiver's cw channel,
Press and hold down to increase/
decrease light intensity
Note:Before the first use, please remove the protective film on the battery.
09.283CT.04337
Press and hold down to increase light
intensity smoothly
Control the receiver's ww channel,
Press and hold down to increase/
decrease light intensity
Press and hold down to decrease light
intensity smoothly
6 zones, click to choose a zone,
press and hold down to turn ON/OFF
corresponding zone
Front side
Back side
Product Data
Output
RF signal
Operation Frequency
868/915/434MHz
Power Supply
3V(1xCR2025 battery)
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
136.3x38.9x10.7mm
• Control 6 zones of RF receiver
• Dual color controller
• Compatible with universal serie RF receiver
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Safety & Warnings
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Pair with RF receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 2:Click the "Learning Key" button on RF receiver to set it into pairing status
Step 3:Choose and click a zone number(e.g. zone 4)
Step 4:Click any of the four buttons
the RF receiver flicker once means the receiver is paired with zone 4 successfully.
,
After pairing choose and click one or multiple zone nunbers , then press and
hold any of the four buttons
Note: one receiver can be paired with max 8 remote controls.
RF LED Receiver
Learning Key
, LED lights connected with
to do the operate