Table of Contents
Advertisement
ADJUSTMENT & OPERATION
Fig. 9
IMPORTANT
USE ONLY 1.2v NiMH AA
1300mAh (Nickel Metal
Hydride) rechargeable
batteries in your microscope.
Using any other type of
battery may damage to your
microscope.
®
ACCU-SCOPE
EXS-210 STEREO MICROSCOPE
(continued)
Replacing the Rechargeable Batteries (Fig. 9)
1. Unplug the microscope from the electrical outlet (if plugged in)
and unplug charger from rear of microscope (if plugged in).
2. Carefully place the microscope on the back of its arm so the
bottom of the microscope base is facing towards you.
3. Open the trap door on the bottom using a small Philips head
(+) screw driver.
4. Replace the three NiMH AA 1300mAh rechargeable batteries.
5. Close the trap door, and place the microscope in an upright
position.
6. Plug the charger to the power receptacle on the back of the
microscope and plug into an electrical receptacle for continued
use while charging.
Allow the LED microscope to charge for 8 hours before using as
cordless.
Replacing the LED Bulbs
The reflected (top) and transmitted (bottom) lights can be used
simultaneously. The lux rating for the reflected illuminator is
7000lux, and the transmitted 18,000 lux by a distance of 70mm.
The life expectancy of the LED bulbs is 20,000 hours. The LED
bulbs are covered by a 1 year manufacturer's warranty.
Should your LED bulbs need replacing, please contact an
authorized ACCU-SCOPE service center or call ACCU-SCOPE
Inc.'s technical service department at 631-864-1000 for an
authorized service center near you.
9
Advertisement
Table of Contents
