Table of Contents
Advertisement
Commit and Activate
1.
Tap Commit to activate the setting.
2.
Under Main tab, select the profile you want to
activate.
3.
Under Status tab, you can see the IP address,
signal strength and quality.
4.
Tap OK to exit the Summit Client Utility.
Tap Start → Boot-Mode. Tap Warm Boot to warm start the terminal and
5.
load the previous settings.
6.
If you want to disconnect the AP, tap Disable
Radio.
16
Copyright 2011 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Advertisement
Table of Contents
