Powering On The Pa500Ii - Unitech PA500IIBTG User Manual

Data collection terminal

Table of Contents

If the battery level becomes low, a status icon appears on the device screen

indicating low

or very low battery

ActiveSync operation to back up your data, and then recharge your device as

soon as possible. If the battery level reaches a low status, the device will enter

a sleep mode and cannot be powered up until the battery is charged. Windows

Mobile 5.0 devices will retain installed applications and data when the main

battery is completely drained for extended periods of time.

Powering On the PA500II

After you have initially charged your device for about 16 hours, the device is

ready to be used. You can now start up your device where you can calibrate

the screen, set up the system time zone, and learn some basic stylus usage.

Turn on your device by pressing the Power button

NOTE:

The PA500II screen ships with a protective plastic film. You may

remove it by peeling from one corner. The screen will be more

susceptible to scratching without the film, but will be more readable.

The unitech PA500II welcome screen appears. The Windows Mobile

screen will appear shortly.

Calibrate the PA500II

The calibrate screen will automatically appear when the unit is

powered-on for the first time or after the system is reset. This screen can

also be accessed at any time by tapping Start → Settings → System tab

→ Screen.

status. In both cases, perform an

on the front panel.

Table of Contents

Pa500ii