Oled Error Messages; Leds - QNAP TS-53B Series User Manual

The panel displays Main Menu 1. TCP/IP.
3. Repeatedly press and hold the Enter button until Main Menu 7. Password appears.
4. Press and hold the Enter button. The change password screen appears.
5. Select Yes by pressing and holding the Enter button. The New Password screen appears.
6. Use the Select and Enter buttons to set the new password.
• Specify a password with 1 to 8 characters. The password can only contain numbers (0 to 9).
• To remove a password, set the new password to blank.
Button
Enter
Select
7. Press Enter after you set the password.

OLED Error Messages

System Message
Sys. Fan Failed
Sys. Overheat
HDD Overheat
CPU Overheat
Network Lost
LAN1 Lost
LAN2 Lost
HDD Failure
Vol1 Full
HDD Ejected
Vol1 Degraded
Vol1 Unmounted
Vol1 Nonactivate

LEDs

LEDs indicate system status and related information when the NAS is powered on. The following LED
information applies only when the drive is correctly installed and when the NAS is connected to the network.
For details on the location of the LEDs, see Components.
Move to the next item in the New Password.
Change a number in the New Password and Verify Password
screens.
The system fan failed.
The system overheated.
The drive overheated.
The CPU overheated.
LAN 1 and LAN 2 are disconnected in failover or are in load-balancing
mode.
LAN 1 is disconnected.
LAN 2 is disconnected.
The drive failed.
The volume is full.
The drive was ejected.
The volume is in degraded mode.
The volume is unmounted.
The volume is not activated.
Usage
Description
TS-x53B User Guide
Basic Operations 42