LifeSpan Workplace C3-DT7 Owner's Manual page 11

DT-7 Desk:
Assembly Instructions
Step 4: Height Adjustment/Console Harness Connections
A. Remove the two upper
screws (13) attaching the
access panel for the height
adjustment control unit.
B. Tilt down and pull
the access panel out
several inches. There are
harnesses pre-installed to
the height controller, so
do not try to fully remove.
C. Attach the round
connector (15) (placed
in the center tray during
desktop assembly) to the
height controller port (16).
D. Connect the 7-pin
rectangular connectors
(14) (one is placed in the
center tray during desktop
assembly and the other
is pre-installed at the
factory).
E. Re-attach the access panel
to the center tray and
tighten the two screws
removed in step A.
F. Plug the power cord into
the receptacle (19).
NOTE: Check to be sure all wires are carefully tucked into the center tray
prior to tightening access panel screws to prevent harness damage.
22
13
Do Not
Remove Screws
15
16
19
Desk Leveling
The desk needs to be leveled prior
to use. The desk comes with two
adjustable feet that can be used
to level the desk and eliminate
rocking. If the desk is rocking on
two of the feet, adjust the two
front feet until all four feet are
sitting securely on the floor.
Desk Height Adjustment
A. To raise the desk, press the up
14
or down arrow until the desk
is at the desired height.
B. To save a height press and
hold the memory preset,
one or two, button for three
seconds. This will save the
current height into memory.
C. The next time the desk
is used, simply press the
memory preset to adjust the desk height to the previously saved
setting.
Safety Key
When using the DT-7 with a
treadmill use safety key (D).
When using the DT-7 with a
bike please use safety key (E).
DT-7 Desk:
Desk Leveling and Height Adjustment
Desk Adjustment Feet
D
Desk
Height
Memory
Pre-Sets
E
23