LifeSpan Workplace C3-DT7 Owner's Manual page 10

DT-7 Desk:
Assembly Instructions
Step 1: Lift Frame Assembly
A. Position the lift frame (1),
left base foot (3) and right
base foot (4) as shown in the
figure to the right. Note the
position of the Workplace
logo as well as the right and
left base feet.
B. Place the lift frame onto
the left and right base feet
mounting bolts and install
the M10 washer (11) and
M10 acorn nut (6).
C. Tighten the four mounting
nuts.
Step 2: Accessory Tray Assembly
A. Remove the four screws
(9) pre-installed in the
bottom of the upright
assembly crossbar.
B. Line the holes in the
accessory tray (10)
with the holes in the
crossbar.
C. Install four M8 washers
and M8*15 bolts (9) and
tighten.
20
1
Workplace
Logo
6
5
A Desk positioning
3
bumpers facing inward
10
9
Step 3: Desktop Assembly
NOTE: It is a good idea to use two people for this portion of the
assembly in order to be sure wires are properly routed and do not get
pinched while installing the desktop.
A. Remove the bolts (7),
washers (5), and nuts
(8) pre-installed in the
upright assembly posts.
B. Hold the desktop (2)
over the lift frame (1)
and place the desk
height control wire
harness (15) and the
4
console wire harness
(14) into the center of
the lift frame (1). Place
the connector ends
towards the center of
the tray for easy access
in the next steps of the
assembly.
C. Set the desktop down
into the mounting brackets (C) on the extension tubes, align the
mounting holes and re-install the hardware removed in step A.
D. Tighten the desktop mounting bolts/nuts.
DT-7 Desk: Assembly Instructions
8
2
14
15
C
1
5
7
C
21