Condenser (Behind Grille) - Sub-Zero ICBPRO3650RH Use & Care Manual

OPERATION
Interior Lighting
FREEZER LIGHTING
Over-and-under models | Lighting is located in upper front
section of the freezer compartment. To remove the light
diffuser, gently compress the diffuser to release it from sup-
porting guides.
Side-by-side models | Freezer basket lighting is located
above the ice container. To access the light bulb, remove
the ice container and push the carrier assembly to the back
of the unit. The bulb will be accessible under the fixed shelf
in front of the ice maker.
Dispenser models | Lighting above the ice container
is accessible by removing the ice container. Refer to ice
container removal on page 6. Once the container has been
removed, remove the light diffuser as described in overhead
lighting. Lighting below the ice container is accessible by
removing the light diffuser. To remove, press the plastic
lip up and pull the diffuser out of the supporting guides.
Freezer basket lighting is located below the fixed shelf on
the back wall of the freezer. To access the light diffuser, first
remove the freezer basket below the fixed shelf. To remove
the light diffuser and access the light bulb, gently compress
the diffuser to release it from supporting guides.
|
8 English
CRISPER LIGHTING
Crisper drawer lighting is located behind the upper crisper
drawer and mounted to the back wall of the refrigerator.
To remove the light diffuser, remove the crisper drawer and
upper crisper shelf. Place both hands under the right and
left sides of the diffuser and push upward. Refer to the
illustration.
CARE RECOMMENDATIONS
Cleaning
INTERIOR CLEANING
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water and baking soda. Rinse and
dry thoroughly. Avoid getting water on lights and control
panel.
CAUTION
Do not use vinegar, rubbing alcohol or other alcohol-
based cleaners on any interior surface.
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly wipe
surface with a water-dampened microfiber cloth followed by
a dry polishing chamois. Always follow the grain of stainless
steel.
CONDENSER CLEANING
CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
The condenser is located behind the flip-up grille. To
access, pull out on the bottom edge of the grille and rotate
upward. Use a soft bristle brush and vacuum to remove
dust and lint from the condenser. Clean the condenser every
three to six months. Refer to the illustration below.
IMPORTANT NOTE: To avoid damaging condenser fins,
vacuum in the direction of the fins (up and down).
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure or damage.
VACATIONS
For extended vacations, turn power off at the control panel.
Empty the unit and block doors open slightly to let fresh
air in and keep interior dry. Water filter should be replaced
before start up.
CONDENSER
Condenser location.