Freezer Baskets; Ice Container; Air Purification System - Sub-Zero ICBPRO3650RH Use & Care Manual

STORAGE
Freezer Storage

FREEZER BASKETS

ICBBI-36F and side-by-side models | To remove, pull
forward until basket stops. Pull the two metal clips located
behind the bottom two corners of the basket forward, then
lift up and out. Refer to the illustration below. To reinstall,
push drawer slides in. Align the basket with slides and push
back until it stops. Press down on the front of the basket to
engage slides.
IMPORTANT NOTE: To remove for models ICBBI-36S,
ICBBI-42S and ICBBI-42SD, the basket must be raised
and pulled through the opening in the door liner after
disengaging.
Over-and-under models | To remove the upper and lower
freezer baskets, lift up and out. Refer to the illustration
below. To reinstall, insert the lower basket into the four
corner retainers. Position the upper basket onto the side
rails and slide back until it clicks.
ICBBI-36F and side-by-side Over-and-under models.
models.
|
6 English

ICE CONTAINER

ICBBI-36F and over-and-under models | To remove, pull
container forward until it stops, then lift out.
Side-by-side models | To remove, pull container forward
until it stops, then lift to clear the carrier assembly along the
back. Pull forward and out. Refer to the illustration below.
Dispenser models | To remove, pull container out partially,
then rotate and pull out. Refer to the illustration below.
Side-by-side models. Dispenser models.
OPERATION

Air Purification System

The advanced air purification system of Sub-Zero built-in
models reduces bacteria, odors and ethylene gas, which
causes premature ripening in fruits and vegetables. The
air purification cartridge has been factory installed and is
located inside the refrigerator, on the back wall.
To initiate air purification, touch on the control panel.
The cartridge will last approximately one year. The
indicator will flash in the control panel display when the
cartridge needs to be replaced.
AIR PURIFICATION CARTRIDGE REPLACEMENT
To access the air purification cartridge, grasp the outside
1
cover from the bottom and rotate upward. Refer to the
illustration below.
Grasp the black cover from the top and rotate down-
2
ward. The cartridge will pop out and can be removed.
Remove the new cartridge from packaging and insert
3
with connector pointing downward.
Once in position, close the black cover. Then rotate the
4
outside cover downward until it closes against the back
wall.
Once the cartridge has been replaced, touch and hold
5
on the control panel for five seconds to reset. The
indicator will appear in the control panel display but
not flash.
Air purification cartridge.