Condenser (Behind Grille) - Sub-Zero BI-30UG Use And Care Manual

C A R E RE C O MM E NDAT I O N S
Cleaning
C ON D E NS E R CL E A NI N G
CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
The condenser is located behind the flip-up grille. To
access, pull out on the bottom edge of the grille and rotate
upward. Use a soft bristle brush and vacuum to remove
dust and lint from the condenser. Clean the condenser every
three to six months. Refer to the illustration below.
To avoid damaging the condenser fins,
IMPORTANT NOTE:
vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure, or damage.
CONDENSER
Condenser location
VAC ATIO N S
For extended vacations, turn power off at the control panel.
Empty the unit and block doors open slightly to let fresh
air in and keep the interior dry. The water filter should be
replaced before start up.
subzero.com | 13