Table of Contents
Advertisement
24) Press as to select an item, and press qw to adjust the setting.
[NON-OVERLAPPED BLACK LEVEL]
Note
f [BRIGHTNESS ADJUST] is a function that makes the increased brightness in black level of the overlapping image area difficult to
notice when [EDGE BLENDING] is used to structure a multi-display screen. The optimal point of correction is set by adjusting [NON-
OVERLAPPED BLACK LEVEL] so the black level of the overlapping image area will be the same level as the non-overlapping area. If the
border area of the part where the image is overlapping and the non-overlapping part gets brighter after adjusting [NON-OVERLAPPED
BLACK LEVEL], adjust the width of the top, bottom, left, or right. Adjust [BLACK BORDER LEVEL] when the width adjustment makes only
the border area darker.
f The joining part may look discontinuous depending on the position you are looking from when a screen with high gain or rear screen is used.
f When structuring a multi-display screen using both horizontal and vertical edge blending, adjust [OVERLAPPED BLACK LEVEL] first before
making adjustments in Step 12). Adjustment method is same as the procedure of [NON-OVERLAPPED BLACK LEVEL].
f If only horizontal or vertical edge blending is used, set all items in [OVERLAPPED BLACK LEVEL] to 0.
f The [AUTO TESTPATTERN] setting changes synchronizing with [AUTO TESTPATTERN] of [COLOR MATCHING].
f Adjustment of the tilt of the border between [NON-OVERLAPPED BLACK LEVEL] and [BLACK BORDER LEVEL] is a function to perform
the adjustment of [GEOMETRY] (x page 90) together with the edge blending. If [NON-OVERLAPPED BLACK LEVEL] is tilted by
correcting the keystone from [KEYSTONE] in [GEOMETRY], perform Steps 17) and 18) to adjust the edge blending according to the shape
of [NON-OVERLAPPED BLACK LEVEL].
[FRAME RESPONSE]
Set image frame delay.
1)
Press as to select [FRAME RESPONSE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[FAST]
*1
[FIXED]
*2
*1 When input signals are other than interlaced signals, [FAST] cannot be set.
*2 Only when moving image signals and still image signals with the vertical scanning frequency of 50 Hz or 60 Hz are input
Note
f [DIGITAL CINEMA REALITY] and [FRAME CREATION] cannot be set when [FRAME RESPONSE] is set to [FAST].
f [FILM DETECTION] in [FRAME CREATION] cannot be set when [FRAME RESPONSE] is set to [FIXED].
f [FRAME RESPONSE] cannot be set while in the four-screen display mode. The [FRAME RESPONSE] setting is disabled when displaying
the four-screen display while [FRAME RESPONSE] is set to anything other than [NORMAL]. Set the [MULTI DISPLAY] menu → [MULTI
DISPLAY MODE] to anything other than [OFF] when using the four-screen display mode.
[FRAME CREATION]
Set the amount of image frame interpolation.
The image with fast movement can be displayed more smoothly by automatically generating the intermediate
frame from the previous and next frame.
1)
Press as to select [FRAME CREATION].
2)
Press the <ENTER> button.
f The [FRAME CREATION] screen is displayed.
3)
Press as to select [FRAME CREATION MODE].
96 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
[BLACK BORDER WIDTH] (Right)
Projection range
[BLACK BORDER LEVEL]
Standard setting.
Simplifies the image processing to reduce image frame delay.
Sets image frame delay to be constant regardless of the image position or magnification.
Edge blending [WIDTH] (Right)
[MARKER] (Red)
Edge blending [START] (Right)
([MARKER] (Green))
[OVERLAPPED BLACK LEVEL] (Right)
Advertisement
Table of Contents
