Table of Contents
Advertisement
f Directly connect the projector with the external device that will output the signal without going through a distributor, etc., when inputting quad
link signals. A phase difference between the signals of Link 1, Link 2, Link 3, and Link 4 may occur, and the image may not be projected
correctly.
f An error in signal detection may occur when an unsteady signal is input to the projector. In such case, set the [DISPLAY OPTION] menu →
[SDI IN] to the content corresponding to the input signal.
For <3G-SDI 1 IN>/<3G-SDI 2 IN> terminals and <3G-SDI 3 IN>/<3G-SDI 4 IN> terminals of the
Interface Board
This is an example when the optional 3G-SDI Terminal Board with Audio (Model No.: TY-TBN03G) is installed in
<SLOT 1>.
SDI input compatible flat panel display
SDI output compatible digital input recorder
Note
f Use a connection cable with 5CFB or higher (such as 5CFB or 7CFB), or Belden 1694A or higher to properly transmit images. Use a
connection cable of 100 m (328'1") length or less.
f Setting the [DISPLAY OPTION] menu → [SLOT IN] is required depending on the connected external device or the input signal.
Set [SDI LINK] in [SLOT IN] when the dual link signal or the quad link signal is input.
f To input the dual link signal, use the cable with same length and same type for connecting to the <3G-SDI 1 IN> terminal and the <3G-SDI 2
IN> terminal, or the <3G-SDI 3 IN> terminal and the <3G-SDI 4 IN> terminal. The image may not be projected correctly when the difference
of the cable length is 4 m (13'1") or more.
f To input the quad link signal, use the cable with same length and same type for connecting to each of <3G-SDI 1 IN>/<3G-SDI 2 IN>/<3G-
SDI 3 IN>/<3G-SDI 4 IN> terminals. The image may not be projected correctly when the difference of the cable length is 4 m (13'1") or
more.
f Directly connect the projector with the external device that will output the signal without going through a distributor, etc., when inputting dual
link signals. A phase difference between the LINK-A signal and the LINK-B signal may occur, and the image may not be projected correctly.
f Directly connect the projector with the external device that will output the signal without going through a distributor, etc., when inputting
quad link signal. A phase difference between the signals of Link 1, Link 2, Link 3, and Link 4 may occur, and the image may not be projected
correctly.
f An error in signal detection may occur when an unsteady signal is input to the projector. In such case, set the [DISPLAY OPTION] menu →
[SLOT IN] to the content corresponding to the input signal.
46 - ENGLISH
Chapter 2 Getting Started — Connecting
SD-SDI signal, HD-SDI signal, or 3G-SDI signal
Advertisement
Table of Contents
