Table of Contents
Advertisement
f The value of input supply voltage cannot be displayed in the self-diagnosis display during standby when the [PROJECTOR SETUP] menu
→ [STANDBY MODE] (x page 136) is set to [ECO].
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1)
Press as to select [SAVE ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
f [PROGRESS] is displayed while saving data.
Note
f Data set from the computer application is not included in [ALL USER DATA].
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1)
Press as to select [LOAD ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f Data registered from a computer is not included in [ALL USER DATA].
[INITIALIZE]
Return various setting values to their factory default settings.
1)
Press as to select [INITIALIZE].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
4)
Press as to select an item to initialize.
[ALL USER DATA]
[REGISTERED SIGNAL]
[NETWORK/E-MAIL]
[LOGO IMAGE]
5)
Press the <ENTER> button.
6)
When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f Even when [ALL USER DATA] is executed, the settings of [UNIFORMITY], [OPERATING MODE], [MAX LIGHT OUTPUT LEVEL], and
[STANDBY MODE] are not initialized.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns all setting values including [REGISTERED SIGNAL], [NETWORK SETUP], [E-mail set up],
and [USER LOGO] to the factory default settings.
The projector enters the standby mode to reflect the setting values.
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in "Deleting the
registered signal" (x page 152).
Returns [NETWORK SETUP] and [E-mail set up] to factory default settings.
Deletes the image registered in [USER LOGO].
ENGLISH - 147
Advertisement
Table of Contents
