Table of Contents
Advertisement
[DISABLE]
Note
f By closing the mechanical shutter, the malfunction of the DLP chip caused by high power laser ray entering the projection lens surface can
be prevented. To close the mechanical shutter, set [MECHANICAL SHUTTER] to [ENABLE] and then set the shutter function to be enabled
(shutter: closed).
f When [MECHANICAL SHUTTER] is set to [ENABLE], it will take approximately 0.5 seconds from when the shutter function is enabled
(shutter: closed) to the shutter function is disabled (shutter: opened).
f When [MECHANICAL SHUTTER] is set to [DISABLE], and the shutter function is used at the environment temperature of around 0 °C
(32 °F), the light source may light up dimly due to warm-up.
Setting [FADE-IN] or [FADE-OUT]
1)
Press as to select [SHUTTER SETTING].
2)
Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [FADE-IN] or [FADE-OUT].
4)
Press qw to switch the item.
[FADE-IN]
[FADE-OUT]
Note
f Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
1)
Press as to select [SHUTTER SETTING].
2)
Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [STARTUP].
4)
Press qw to switch the item.
[OPEN]
[CLOSE]
Setting [SHUT-OFF]
1)
Press as to select [SHUTTER SETTING].
2)
Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [SHUT-OFF].
4)
Press qw to switch the item.
[LAST USED]
[OPEN]
[CLOSE]
124 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Leaves the mechanical shutter open and turns off only the light source when the shutter function is
enabled (shutter: closed).
Item
[OFF]
[0.5s] - [10.0s]
The projector goes into projection mode with the shutter function disabled (shutter: opened) when the
power is turned on.
The projector goes into projection mode with the shutter function enabled (shutter: closed) when the
power is turned on.
The projector goes into standby mode with the condition of the mechanical shutter maintained when
the projector is switched off.
The projector goes into standby mode with the mechanical shutter opened when the projector is
switched off.
The projector goes into standby mode with the mechanical shutter closed when the projector is
switched off.
Adjustment
Does not set fade-in or fade-out.
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.
Advertisement
Table of Contents
