Table of Contents
Advertisement
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[1]
[2]
[3]
Note
f The effect may be difficult to notice depending on the image.
f Switch the setting when the image looks unnatural due to delay of image or generation of noise.
f [FRAME CREATION] is disabled and cannot be selected when [FRAME RESPONSE] is set to [FAST].
f The [FRAME CREATION] setting is disabled and cannot be selected when the [DISPLAY OPTION] menu → [SIMUL INPUT SETTING]
(x page 104) is set to [AUTO(x2-speed)] or [AUTO(x4-speed)] and the image in simultaneous format is displayed.
f The [FRAME CREATION] setting is disabled and cannot be selected while in the four-screen display mode. The four-screen display mode
can be cancelled by setting the [MULTI DISPLAY] menu → [MULTI DISPLAY MODE] to [OFF]. (x page 149)
f The [FRAME CREATION] setting is disabled while displaying the internal test pattern.
Setting [FILM DETECTION]
Set the film detection function to enhance the video resolution by determining if it is a content that the telecine is
performed on the input signal.
1)
Press as to select [FRAME CREATION].
2)
Press the <ENTER> button.
f The [FRAME CREATION] screen is displayed.
3)
Press as to select [FRAME CREATION MODE].
4)
Press qw to select a mode from [1], [2], or [3].
5)
Press as to select [FILM DETECTION].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f The video resolution is not changed even if [FILM DETECTION] is set to [ON] for the contents that the telecine is not performed on the input
signal.
The contents which telecine is performed is the contents that the film image is converted to the video image.
f [FILM DETECTION] cannot be set when a signal for the content with vertical scanning frequency of 30 Hz, 25 Hz, or 24 Hz is input.
f [FILM DETECTION] cannot be set when [FRAME RESPONSE] is set to [FIXED].
[QUAD PIXEL DRIVE]
Set the enable/disable of the QUAD PIXEL DRIVE function to enhance the resolution of the projected image.
1)
Press as to select [QUAD PIXEL DRIVE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f When [QUAD PIXEL DRIVE] is set to [ON], the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] (x page 120) → [OSD SIZE] cannot
be set.
f [QUAD PIXEL DRIVE] is fixed to [ON] when the [POSITION] menu → [GEOMETRY] (x page 90) is set to anything other than [OFF].
Chapter 4 Settings — [ADVANCED MENU] menu
Disables the frame creation function.
Sets the amount of interpolation weaker.
Sets the amount of interpolation midway.
(Factory default setting)
Sets the amount of interpolation stronger.
Disables the film detection function.
Enables the film detection function. The video resolution is enhanced for the contents that telecine is
performed on the input signal.
Enables the QUAD PIXEL DRIVE function.
Disables the QUAD PIXEL DRIVE function.
ENGLISH - 97
Advertisement
Table of Contents
