Table of Contents
Advertisement
2. Installation
Switch off the ignition and disconnect the vehicle's battery! The interface needs a
permanent 12V source. If -according to factory rules- a disconnection of the battery has to
be avoided, it should be sufficient to use the vehicle's sleep-mode. In case, the sleep-mode
doesn't succeed, the battery has to be disconnected with a resistor lead.
The Interface needs a permanent power supply! If power isn't directly taken from the
battery, the connection's power has to be checked for being start-up proven and
permanent.
Before a final installation, we recommend a test-run to ensure the compatibility of the
vehicle and the interface. Due to changes in the production of the vehicle manufacturer
there's always a possibility of incompatibility.
2.1.
Place of installation
2.1.1. Place of installation – video-interface
The video-interface has to be installed on the backside of the head-unit.
2.1.2. Place of installation - daugter PCB
The daughter PCB has to be installed inside the monitor housing.
Version 29.01.2021
HW: CAM(V100)/(V21)
RL4-MZD88
Advertisement
Table of Contents
