[Network Status]; [Initialize] - Panasonic PT-VW540 Operating Instructions Manual

[WEB CONTROL]
[PJLink CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[AMX D. D.]
4) Press as to select [OK] and press the <ENTER> button.

[NETWORK STATUS]

Displays the network status.
1) Press as to select [NETWORK STATUS].
2) Press the <ENTER> button.
f The [NETWORK STATUS] screen is displayed.
[WIRED LAN]

[INITIALIZE]

This function is used to return various setting values of [NETWORK] to the factory default value.
1) Press as to select [INITIALIZE].
2) Press the <ENTER> button.
3) When the [INITIALIZE] screen is displayed, press qw to select [OK] and then press the <ENTER> button.
Note
f If the [SECURITY] menu → [PASSWORD] is set to [ON], the [PASSWORD] screen will be displayed when [INITIALIZE] is selected and the
<ENTER> button is pressed. Continue your operation after entering the security password set for the projector.
90 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
Set to [ON] to control with the web browser.
Set to [ON] to control with the PJLink protocol.
Set to [ON] to control with the <SERIAL IN> terminal control command format (x page 124). Refer
to "Control commands via LAN" (x page 120).
Set the port number used for command control.
Set to [ON] to control with Crestron Connected
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
Displays the network information of the wired LAN that set on the projector.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
[MAC ADDRESS]
of Crestron Electronics, Inc.
TM
Displays the usage state of the DHCP server.
Displays the IP address.
Displays the subnet mask.
Displays the default gateway.
Displays the address of the preferred DNS server.
Displays the address of the alternate DNS server.
Displays the MAC address of wired LAN.