[Control Device Setup] - Panasonic PT-VW540 Operating Instructions Manual

[CONTROL DEVICE SETUP]

Enable/disable the button operations on the control panel and the remote control.
1) Press as to select [CONTROL DEVICE SETUP].
2) Press the <ENTER> button.
f The [CONTROL DEVICE SETUP] screen is displayed.
3) Press as to select one item between [CONTROL PANEL] and [REMOTE CONTROLLER].
[CONTROL PANEL]
[REMOTE CONTROLLER]
4) Press qw to switch between [ENABLE] and [DISABLE].
f You can limit the control method to the control panel or the remote control.
[ENABLE]
[DISABLE]
f When you change [ENABLE] to [DISABLE], proceed to Step 5).
5) When the confirmation screen is displayed, press qw to select [OK], and then press the <ENTER>
button.
Note
f When a button operation is performed on the device set to [DISABLE] , the [PASSWORD] screen is displayed.
To continue operations, enter the security password.
f The [PASSWORD] screen will disappear when there is no operation for approx. 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROLLER] are set to [DISABLE], the projector cannot be turned off
(cannot enter standby).
f Even when you set button operations on the remote control to be disabled, operations of the <ID ALL> and <ID SET> buttons on the remote
control are enabled.
88 - ENGLISH
Chapter 4 Settings - [SECURITY] menu
You can limit the control method to the control panel.
You can limit the control method to the remote control.
Enable the operation of all buttons.
Disable the operation of all buttons.