Making Adjustments And Selections; Switching Off The Projector - Panasonic PT-VW540 Operating Instructions Manual

Making adjustments and selections

It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
1) 8) 5) 9)
4)
1) Roughly adjust the focus of the image with the focus lever. (
2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (
f Refer to "Navigating through the menu" (
3) Press the input selection buttons on the remote control or the <INPUT SELECT> button on the control
panel to select the input signal. (
f The buttons that can be used on the remote control are as follows.
<COMPUTER 1> button, <COMPUTER 2> button, <VIDEO> button, <HDMI 1> button, and <HDMI 2>
button
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (
5) Adjust the size of the image to match the screen with the zoom lever.
6) Adjust the vertical projection position with the vertical lens shift dial.
7) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
8) Adjust the focus again with the focus lever.
9) Adjust the size of the image to match the screen with the zoom lever again.
Note
f When the projector is switched on for the first time after purchase or the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is executed, the
[INITIAL SETTING] screen is displayed after projection starts. Refer to "When the initial setting screen is displayed" (

Switching off the projector

1) Press the power <v/b> button.
f The [POWER OFF] confirmation screen is displayed.
42 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector
4)
page 29)
Æ
Æ
page 44)
Æ
3) 1)
6)
Æ
page 45)
page 53) for the operation of the menu screen.
1)
2)
2)
7)
3)
3)
7)
Æ
page 46)
page 40).
Æ