Direct Power Off Function - Panasonic PT-VW540 Operating Instructions Manual

2) Press qw to select [OK], and press the <ENTER> button.
(Or press the power <v/b> button again.)
f Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> on the projector lights in
orange. (The fans keep running.)
3) Wait until the power indicator <ON(G)/STANDBY(R)> on the projector lights or blinks in red.
f The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights or blinks in red.
4) Disconnect the plug of the power cord from the outlet.
Note
f While the power indicator <ON(G)/STANDBY(R)> is lighting in orange, the luminous lamp is being cooled down and the projector cannot be
turned on. Wait until the power indicator <ON(G)/STANDBY(R)> starts lighting or blinking in red to turn on the projector again.
f Even if the power is turned off by pressing the power <v/b> button, the projector consumes power if the power plug is connected
to the outlet.
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is
restricted, but the power consumption during standby can be conserved.

Direct power off function

When the plug is disconnected from the outlet or the power is turned off by the circuit breaker in the ceiling mount
case while the projection is going on, the projector can respond with direct power off function. Therefore, it is also
safe in case a power outage occurs or the power cord is pulled out immediately after the projector is switched off.
Attention
f Do not disconnect the power cord from the wall outlet or turn off the circuit breaker switch in about 1 minute after the lamp is lit. Doing so
may cause the lamp fail to light while you powering on the projector next time, or result in premature deterioration of the luminous lamp.
Note
f If the [PROJECTOR SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY] and the projector was turned off by using the circuit
breaker directly while projecting during the last time of use, the power indicator <ON(G)/STANDBY(R)> will light in green a while after the
circuit breaker is turned on, and then projection of the image will start.
f If the projector is shut down with the direct power off function, it may take longer than usual to be ready for projection when the projector is
switched on the next time.
Chapter 3 Basic Operations - Switching on/off the projector
ENGLISH - 43