Panasonic PT-VW540 Operating Instructions Manual page 100

1 [DHCP ON], [DHCP OFF]
To enable the DHCP client function, set to [DHCP ON].
2 [IP ADDRESS]
Enter the IP address when not using a DHCP server.
3 [SUBNET MASK]
Enter the subnet mask when not using a DHCP server.
4 [DEFAULT GATEWAY]
Enter the default gateway address when not using a
DHCP server.
5 [DNS1]
Enter the DNS1 server address.
Permissible characters for the entry of DNS1 server
address (preferred):
Numbers (0 - 9), period (.)
(Example: 192.168.0.253)
Note
f When you use the "Back" and "Forward" functions of the browser, a warning message "Page has Expired" may appear. In that case, click
[Network config] again since the following operation will not be guaranteed.
f Changing LAN settings while connected to the LAN may cause the connection to cut out.
[Ping test] page
Check whether the mail server, POP server, DNS server, etc. is connected to the network.
Click [Detailed set up] → [Ping test].
1 [Input IP address]
Enter the IP address of the server to be tested.
2 [Submit]
Executes the connection test.
[ECO management set up] page
Settings related to the ECO management function of the projector can be made.
Click [Detailed set up] → [ECO management set up].
100 - ENGLISH
Chapter 5 Operation of Function - Web control function
6 [DNS2]
Enter the DNS2 server address.
Permissible characters for the entry of DNS2 server
address (alternate):
Numbers (0 - 9), period (.)
(Example: 192.168.0.254)
7 [Back], [Next]
Click the [Back] button to return to the original screen.
The current settings are displayed by pressing the [Next]
button.
Click the [Submit] button to update the settings.
1
2
3 Example of display when the connection has
succeeded
4 Example of display when the connection has failed
3
4
1
2
3
4
5
6
7
8