Parts For Ceiling Mount (Optional); Screen Size And Throw Distance - Panasonic PT-VW540 Operating Instructions Manual

Attention
f The angle sensor cannot detect whether it is the "Installation prohibited posture" in the above figure. Do not use the projector tilted at an
angle that exceeds ±30° from the horizontal plane. It may reduce the life of the components. (x page 16)

Parts for ceiling mount (optional)

This requires an optional ceiling mount bracket. Be sure to use the Projector Mount Bracket together with the
ceiling mount bracket for high ceilings or low ceilings.
Model No.:
① ET-PKL100H (for high ceilings), ET-PKV400B (Projector Mount Bracket)
② ET-PKL100S (for low ceilings), ET-PKV400B (Projector Mount Bracket)
f Use only the ceiling mount brackets specified for this projector.
f Refer to the Installation Instructions for the ceiling mount bracket when you install the bracket and the projector.
Attention
f To ensure projector performance and security, installation of the ceiling mount bracket must be carried out by your dealer or a qualified
technician.

Screen size and throw distance

Refer to the screen size and projection distances to install the projector. Image size and image position can be
adjusted in accordance with the screen size and screen position.
f Following illustration is prepared on the assumption that the projected image size and position have been
aligned to fit full in the screen.
L (LW/LT) *
1
SH
SW
H
SD
*1 LW : Minimum distance
LT : Maximum distance
Attention
f Before installing, please read "Precautions for Use". (
30 - ENGLISH
Chapter 2 Getting Started - Setting up
Projected image
SW
Projection distance
Image height
Image width
Distance from the center of lens to the image lower end
Projected image size
Æ
page 16)
Screen
L (LW/LT)
L (LW/LT)
Screen
(Unit: m)