Table of Contents
Advertisement
5 Operation
5.8.3 View data
1.
Press and hold the
The
indicator flashes, and the data stored in that location is
displayed.
2.
Press the
3.
Press the
different modes.
4.
Press and hold the
exit View data mode.
5.8.4 Clearing the memory from data
1.
Press and hold the
2.
In View data mode, press and hold the
for 3 seconds to clear all data.
5.9 Alarm settings
High and low alarm thresholds can be set for moisture and humidity measure-
ments. If either of the thresholds is exceeded during the measurement, the meter
beeps and the corresponding alarm indicator is displayed: the low alarm indicator
or the high alarm indicator
The default setting for the moisture and humidity alarms is off.
1.
To enter the alarm set mode, do one of the following:
•
To enter the Moisture alarm set mode, press and hold the
for 2 seconds.
•
To enter the Humidity alarm set mode, press and hold the
for 2 seconds.
The current high threshold or OFF (if the alarm is disabled) is flashing on the
main display.
2.
To switch from OFF to the numerical display, simultaneously press the
and
buttons.
#T559822; r.9065/9080; en-US
button for 2 seconds to enter View data mode.
or
button to step through the memory locations.
,
, or
button for 2 seconds until a single beep sounds to
button for 2 seconds to enter View data mode.
.
button to display the stored data for the
and
buttons simultaneously
button
button
18
Advertisement
Table of Contents
