Selecting Measurement Units; Storing And Recalling Measurements - FLIR MR7 User Manual

5 Operation

5.7 Selecting measurement units

There are two sets of units; US and metric. The unit setting can be changed at
any time in any mode, by pressing and holding the
The unit setting applies to all modes. It is not possible to, for example, display
moisture in g/kg while showing temperature in ℉.
US unit setting:
• Temperature is displayed in degrees Fahrenheit (℉).
• Mixing ratio is displayed in grains per pound (GPP).
• Vapor pressure is displayed in millibars (mBar).
Metric unit setting:
• Temperature is displayed in degrees Celsius (℃).
• Mixing ratio is displayed in grams per kilogram (g/kg).
• Vapor pressure is displayed in kilopascals (kPa).

5.8 Storing and recalling measurements

5.8.1 Datalogger memory locations
The meter has 20 datalogger memory locations for the storage of measurement
data. Each memory location stores the current readings for all operating modes,
with the current unit settings. Thus, each location contains moisture, humidity,
ambient temperature, and IR temperature data.
5.8.2 Storing a measurement
1. Press the
The data is saved to the memory location shown by the
The memory location indicator then advances to the next location. When the
20 memory locations are full, the meter overwrites saved readings, starting
with memory location 1.
#T559822; r.9065/9080; en-US
button to capture and store the currently displayed readings.
button for 2 seconds.
indicator.
17