Installing The Gl1 Electromechanical Gate Lock; Perform A Pre-Installation Survey - Assa Abloy Securitron GL1 Installation Instructions Manual

Installing the GL1 Electromechanical
Gate Lock
Installation Concerns
CAUTION:
• Installation should be performed by a qualified service person, who
conforms to all local codes and complies with The National Electrical
Code (or equivalent).
• The FMK-SL (Sliding Gate) and the FMK-SW (Swing Gate) mounting
bracket kits are recommended for installing the GL1.
• The GL1 must be mounted in the upright vertical position with the
conduit opening on the bottom.
• The GL1 should not be used for dual swing gates.

Perform a Pre-Installation Survey

Due to the variety of mounting configurations available with this product,
it is strongly recommended that an initial physical survey and
assessment be made of the actual area where the lock will be installed to
determine the optimal method of mounting prior to installation. The
following should be considered:
• Physical strength of mounting areas: It is recommended that the
structural integrity of mounting surfaces be strong enough to meet or
exceed the holding force of the lock.
• Protection of the lock from external attack: The lock and the wiring
must be protected to a reasonable degree from potential damage
due to intruders or vandals.
• Convenience and accessibility of area to be protected: The lock
It is vital that all welding be completed prior to
making any electrical connections to the mounted
GL1. Welding in or around an electrically-connected
lock assembly can cause damage to the electronic
components.
5
500-22090, Rev A