Table of Contents
Advertisement
Portrait setting and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Note
f In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu vertically, change the [OSD ROTATION] setting in the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY]
(x page 135).
f The projector has a built-in angle sensor. The attitude of the projector is automatically detected by setting [FLOOR/CEILING] to [AUTO] in
the [PROJECTOR SETUP] menu → [PROJECTION METHOD].
r Angle sensor
The range of the installation attitude that is detected by the angle sensor built-in the projector is as follows.
Interface Board (optional)
This projector is equipped with two SLOT NX-specification slots.
There are four SDI input terminals and one DIGITAL LINK input terminal equipped on this projector as the
standard video input terminals. The input for HDMI, DVI-D, and SDI can be added by installing the optional
Interface Board in the slot.
Attention
f Requesting a qualified technician to install or remove the optional Interface Board is recommended. A malfunction may occur due to static
electricity. Consult your dealer.
Chapter 2 Getting Started — Setting up
Setting value
[FRONT]
Set in accordance with the image
to project.
Floor standing installation
Floor standing installation
Projection direction
Portrait setting and projecting from the rear
(Using the translucent screen)
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
30°
Ceiling mount installation
30°
Setting value
[REAR]
Set in accordance with the image
to project.
ENGLISH - 39
Advertisement
Table of Contents
