Table of Contents
Advertisement
r Connecting terminals
7
8
1
<DC OUT 1> terminal/<DC OUT 2> terminal
This is the USB terminal dedicated for power supply. (DC 5 V,
maximum 900 mA)
Use this terminal when a power supply is required to wireless
display adapters and wireless LAN Ethernet converters, etc.
2
<REMOTE 1 IN> terminal/<REMOTE 1 OUT> terminal
These are terminals to connect the remote control for serial
control in a multiple projector environment.
3
<REMOTE 2 IN> terminal
This is a terminal to remotely control the projector using the
external control circuit.
4
<SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
5
<SERIAL OUT> terminal
This is a terminal to output the signal connected to the <SERIAL
IN> terminal.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [NORMAL], power can be supplied by using the <DC OUT 1>
terminal or the <DC OUT 2> terminal even while the projector is in standby mode. If [ECO] is set, power cannot be supplied in standby
mode.
Chapter 1 Preparation — About your projector
1
2
3
9
4
5
10
6
<MULTI PROJECTOR SYNC IN> terminal/<MULTI
PROJECTOR SYNC OUT> terminal
This terminal is used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
7
Slots (<SLOT 1>, <SLOT 2>)
There are SLOT NX-specification slots to install the optional
Interface Board internally.
8
Slot cover
9
<DIGITAL LINK/LAN> terminal
This is the LAN terminal to connect to the network. This is also
used when connecting a video signal transmission device via
the LAN terminal.
10 <SDI IN 1> terminal/<SDI IN 2> terminal/<SDI IN 3>
terminal/<SDI IN 4> terminal
These are terminals to input SDI signals.
6
ENGLISH - 31
Advertisement
Table of Contents
