Vivint Element CT200 Installation Manual page 41

STAGING
1 . From the Home screen, press
and hold the SIDE button for
three (3) seconds .
2 . Press DOWN to highlight
Installer, then press the SIDE
button .
3 . Press DOWN to highlight
Comfort, then press the SIDE
button .
4 . Press DOWN to highlight
Staging, then press the SIDE
button . The current staging
value displays .
5 . Press UP or DOWN to change the value, then press the SIDE
button to confirm.
NETWORK
Network settings enable you to link (connect) the Thermostat to a
Z-Wave Network, and to reset the network connection .
LINK
Before starting this procedure, go
to your Vivint panel and prepare
it for new devices . Once it is
ready, link the Thermostat to the
network .
1 . From the Home screen, press
and hold the SIDE button for
three (3) seconds .
2 . Press DOWN to highlight
Installer, then press the SIDE
button .
3 . Press DOWN to highlight
Network, then press the SIDE
button .
4 . Press DOWN to highlight Link, then press the SIDE button .
The current networking status displays .
Vivint Element CT200 Operation Guide
Customization
START STAGE
2 WHENEVER
3.5°
OFF TARGET
NETWORK
STATUS
Unlinked
Link
41