Vivint Element CT200 Installation Manual page 38

Display
The Thermostat display can
operate in one of two modes:
Approach or Button Tap .
Approach means that the device's
display will automatically turn
on when it senses you approach
within 4 (four) feet of the unit .
Button Tap means that you will
have to press one of the buttons
on the unit to wake the display .
1 . From the Home screen, press
and hold the SIDE button for
three (3) seconds .
2 . Press DOWN to highlight Display, then press the SIDE button . The
current Display On behavior has a check mark next to it .
3 . Press UP or DOWN to select a behavior, then press the SIDE
button to confirm.
Info
Information about the Thermostat device includes:
POWER: The power supply the
unit is currently using
(batteries, C-wire, and/or
transformer) .
BATTERY: How much battery
power is currently left, if
batteries are installed in
the unit .
HEATING: The heating setting the
system is currently using .
ACTIVE RELAYS: The wires
currently being used by
the system .
NETWORK: Whether or not the unit is currently connected to a
Z-Wave network .
SOFTWARE: The current software and firmware versions the unit is
using .
38
Vivint Element CT200 Operation Guide
Customization
DISPLAY ON:
Approach
Button Tap
INFO
POWER
24VAC
BATTERY
85%
HEATING
HEAT PUMP
AUX. HEAT
ACTIVE RELAYS
Y, O, G
NETWORK
CONNECTED
SOFTWARE
D-V1.23
Z-V1.23