Connecting To A Z-Wave Network - Vivint Element CT200 Installation Manual

You must connect the Thermostat to a Z-Wave network .
This unit cannot operate without a network connection .
Connecting the Thermostat to a Z-Wave
The Vivint Element Thermostat is a Z-Wave® compliant thermostat .
It has an onboard radio that can be connected to an existing
Z-Wave® network . This device can be used on a network with
products from different vendors.
1 . Set your primary controller to INCLUDE mode to add the
thermostat as a node on your network (see your specific
controller's User Manual for detailed instructions) .
2 . The Thermostat main screen
shows a welcome message . Press
the SIDE button to continue .
3 . When your primary controller
is ready to connect to the
Thermostat, press the SIDE
button to connect . This initiates
the network connection process .
The Thermostat's screen says
"Connecting."
• If the connection fails, the
screen says "Connection failed."
Press the SIDE button to try connecting again .
5 . When the Thermostat has
successfully joined a Z-Wave
network, the screen displays the
message "Connected! Complete
your setup on the VIVINT panel ."
Press the SIDE button to continue .
6 . The Thermostat displays the
Home screen, with the device
status of "OFF" and the current
room temperature . You can now
configure the thermostat to work
with your system .
Your primary controller indicates that the thermostat was
successfully added to its network (see your specific controller's User
Manual for details) .
Vivint Element CT200 Installation Guide
Setup
Network
®
HELLO.
SET UP YOUR
ELEMENT
THERMOSTAT
THROUGH THE
VIVINT PANEL
OK
OFF
70
2
6
15