Vivint Element CT200 Installation Manual page 35

Vivint Element CT200 Operation Guide
Product Overview
Z-Wave and Thermostat Programs
The Thermostat must be connected to a Z-Wave network in order to
operate . Use your Z-Wave application to adjust the heating and cool-
ing programs that the Thermostat uses to run your system . You can
temporarily override target temperatures and change system modes
from the thermostat, but you must use the Z-Wave application to
make permanent changes to programs .
Compressor Protection
The Thermostat has a minimum cycle time of four (4) minutes to
protect your compressor from excessive wear from responding to
thermostat changes . The Home screen shows an hour glass and the
message "Please Wait". The compressor will not come on until the
four-minute delay is over .
35