Power Supply - Vivint Element CT200 Installation Manual

Power Supply

While the thermostat can run without batteries on C-wire power,
you should install batteries as well to provide power to the unit
during outages . See the Thermostat Battery Cautions .
1 . Install four (4) AA alkaline batteries following the marked polarity
in the battery compartments. Insert the battery negative end first
against the spring, then push the positive end in .
2 . With all the wires connected and the unit attached to the wall, it
is time to turn the AC power back on . Reconnect the power at the
breaker you used to switch it off. The Thermostat will power-up in
the OFF mode .
3 . Your Thermostat is not yet configured to operate your HVAC
system . You must now connect your thermostat to a Z-Wave
Network and configure the HVAC and Heat Source settings.
Battery Installation
12
Vivint Element CT200 Installation Guide
Wiring