Vivint Element CT200 Installation Manual page 39

1 . From the Home screen, press and hold the SIDE button for three
(3) seconds .
2 . Press DOWN to highlight Info, then press the SIDE button .
Information about the Thermostat displays .
3 . Press UP or DOWN to scroll through the available information .
Installer
Installer settings control the following Thermostat functions:
EQUIPMENT: heating, cooling, humidity control, and fan behavior
COMFORT: swing, differential, and other settings
NETWORK: the Thermostat's connection to a Z-Wave Network
TESTING: the Thermostat's connection to your equipment
RESET: resetting the Thermostat's software to factory default
EQUIPMENT
The Equipment settings menu is
typically used during installation
of the Thermostat . The options in
this menu enable you to set the
heating, cooling, humidity control,
and fan equipment behavior .
See the Installation Guide's Setup section for information on setting
those options .
COMFORT
Comfort settings enable you to control:
CALIBRATION: Offsets the unit's temperature display
CYCLING: This feature enables you to set the acceptable variance
in temperature between the Thermostat's setting and the
current room temperature before the heating or cooling
system will turn on . The Cycling range can be from 0 .5 to
4 .0F ( .25 to 2C) . For example, if Cycling is set to 2 .0°F and
the Thermostat is set to 70°F target temperature, the heat
cycle will start when the room temperature drops to 68°F .
Similarly, the cooling system will start when the room
temperature increases to 72°F . The HVAC runs until the
room reaches the target temperature, and then shuts off.
Vivint Element CT200 Operation Guide
!
WARNING
Be sure to turn the thermostat
operating mode to OFF before
changing HVAC setup
Customization
39