Figure 3-5. Power Input; Table 3-4. 150 Pin Hse Connector (Seam-30-03.5-L-05-2-A-K-Tr) - Texas Instruments TMDS64DC01EVM User Manual

www.ti.com
3.3.3 Power Section
All necessary power required for the IO Link/Breakout Board are provided from the HSE connector and on board
24 V DC supply via DC jack. Power Good LED's are provided for 5 V, 3.3 V and 1.8 V.
power section of the Breakout board.
3.3.3.1 Power Input
Nominal Output Voltage: 24V DC
Maximum Output Current: 2A
Plug Type: 2.1mm I.D. x 5.5mm O.D x 9mm Barrel Jack
TI recommends using an external power supply or power accessory that complies with applicable
regional safety standards such as (by example) UL, CSA, VDE, CCC, PSE, and so forth.
3.3.4 Board Mating Connections
The pinout for the mating connectors of the IO Link/Breakout Board are listed in
The following HSE Connector pin names do not indicate exhaustive SoC Pin functionality. For a full list
of pin and signal functions, see the device-specific GP EVM User's Guide and data sheet.

Table 3-4. 150 Pin HSE Connector (SEAM-30-03.5-L-05-2-A-K-TR)

Pin Name
A1
A2
A3
A4
SPRUJ06 – OCTOBER 2021
Submit Document Feedback

Figure 3-5. Power Input

Note
Note
Net Name
VCC_5V0_HSE
VCC_5V0_HSE
VCC_5V0_HSE
PRG0_MDIO0_MDIO
Copyright © 2021 Texas Instruments Incorporated
Figure 3-5
Table 3-4.
Pin Name Net Name
B1 SOC_SPI1_MISO
B2 SOC_SPI1_MOSI
B3 DGND
B4 PRG0_PRU1GPO8
TMDS64DC01EVM and TMDS243DC01EVM User's Guide
System Description
shows the
11