Step 17 Setting The Indoor Unit Addresses And The Installation Options; Common Steps For Setting The Addresses And Options - Samsung AC BN6DCH Series Installation Manual

Installation Procedure
Step 17 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and
the installation options in a batch: set both of them
respectively.
Common steps for setting the
addresses and options
AR-KH**U remote control (for 360 cassette only)
Entering the mode for
setting the options
Temperature
button
Timer button
NOTE
• The remote control display may vary depending on
the model.
26
English
1 Enter the mode for setting the options:
a Remove the batteries from the remote control.
b While holding down the
c Make sure that you are entered to the mode for
Setting the option 2 Set the option values.
values
• The total number of available options are 24: SEG1 to
SEG24.
Mode button
• Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
Wheel
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the following
SEG1
0
SEG7
1
SEG13
2
SEG19
3
(Timer) buttons simultaneously, insert the
batteries into the remote control.
setting the options:
CAUTION
SEG2 SEG3 SEG4
X X
SEG8 SEG9 SEG10
X X
SEG14 SEG15 SEG16
X X
SEG20 SEG21 SEG22
X X
On (SEG1 to SEG12)
(Temp) and
SEG5 SEG6
X X X
SEG11 SEG12
X X X
SEG17 SEG18
X X X
SEG23 SEG24
X X X
Off (SEG13 to SEG24)