Table of Contents
Advertisement
Installation Procedure
CAUTION
• Make sure that the connection parts are not exposed
to outside.
• Be sure to use insulation tape and a contraction tube
made of approved reinforced insulating materials
that have the same level of withstand voltage with
the power cable. (Comply with the local regulations on
extensions.)
WARNING
• In case of extending the electric wire, please DO NOT
use a round-shaped Pressing socket.
– Incomplete wire connections can cause electric
shock or a fire.
Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and the
installation options in a batch: set both of them respectively.
Common steps for setting the addresses and options
Entering the
mode for setting
the options
High Temp button
Low Temp button
20
English
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
b While holding down the
c Make sure that you are entered to the mode for
2 Set the option values.
• The total number of available options are 24: SEG1 to SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page options
used by the previous remote control models, the modes to
set values for these options are skipped automatically.
• Set a 2-digit value for each option pair in the following order:
SEG23 and SEG24
Setting the
SEG1
option values
0
SEG7
1
Mode button
SEG13
High Fan button
2
Low Fan button
SEG19
3
and then insert them again.
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
setting the options:
CAUTION
SEG2
SEG3
SEG4
X
X
SEG8
SEG9
SEG10
X
X
SEG14
SEG15
SEG16
X
X
SEG20
SEG21
SEG22
X
X
On (SEG1 to SEG12)
(High Temp) and
SEG5
SEG6
X
X
X
SEG11
SEG12
X
X
X
SEG17
SEG18
X
X
X
SEG23
SEG24
X
X
X
Off (SEG13 to SEG24)
Advertisement
Table of Contents
