Step 14 Setting The Indoor Unit Addresses And The Installation Options - Samsung AM RN4 CH Series Installation Manual

Installation Procedure
WARNING
• In case of extending the electric wire, please DO NOT
use a round-shaped Pressing socket.
– Incomplete wire connections can cause electric
shock or a fire.
Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and
the installation options in a batch: set both of them
respectively.
Common steps for setting the addresses and
options
Entering the mode
for setting the
options
High Temp button
Low Temp button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the
20
English
2 Set the option values.
• The total number of available options are 24: SEG1 to
SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the following
order: SEG2 and SEG3 SEG4 and SEG5 SEG6 and
SEG8 SEG9 and SEG10 SEG11 and SEG12 SEG14
and SEG15 SEG16 and SEG17 SEG18 and SEG20
SEG21 and SEG22 SEG23 and SEG24
Setting the option
values
SEG1
SEG7
Mode button
High Fan button
Low Fan button
SEG13
SEG19
(High Temp) and
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
CAUTION
SEG2 SEG3 SEG4
0 X X X
SEG8 SEG9 SEG10
1 X X X
SEG14 SEG15 SEG16
2 X X X
SEG20 SEG21 SEG22
3 X X X
On (SEG1 to SEG12)
SEG5 SEG6
X X
SEG11 SEG12
X X
SEG17 SEG18
X X
SEG23 SEG24
X X
Off (SEG13 to SEG24)